How To Guide: James Bond Shaving Kit
STEP 1
Shave Oil
Pre Shave Oil under Shave Gel
After cleaning your face and softening your stubble, pat your skin dry and apply several drops of Shave Oil into the palm of one hand.
Rubbing your hands together apply the oil to the areas of your face and neck to be shaved.
Tip:
Always use the hottest razor blade possible – as hot steel cuts more efficiently than cold steel.
Analyze the way your beard grows. Shave with the direction then across the direction, try not to shave against as that lifts too much skin and can cause razor burn.
STEP 2
Shave Gel
Whenever You Shave
Apply enough Shave Gel directly on top of the Shave Oil to give you adequate protection from the razor blade.
With the Shave Oil and Shave Gel applied then shave in small strokes, with the beard growth, using a hot razor blade.
Rinse the shave products off with cool water and then follow with After Shave Balm and Skin Protector.
Tip:
This is a low lather gel – purposely without harsh foaming chemicals
Suitable for those with problem/sensitive skin allowing you to shave around sensitive areas (such as acne, moles and scars).
STEP 3
After Shave Balm
After You Shave
After rinsing your Shave Gel, pat dry the shaved areas of your face and neck.
Apply a pea sized amount of VITAMAN's After Shave Balm to the areas of your face and neck that have been shaved.
Leave a few minutes to absorb into your skin.
STEP 4
Skin Protector:
2 x Daily AM/PM
Holding the airless serum container upright, turn the top of the container, until it locks in place.
Apply two pumps of Skin Protector to your fingertips then lightly smooth onto your face, neck and eye lid area.